Your company has a LAN in its downtown office and has now set up a LAN in the manufacturing plant in the suburbs. To enable everyone to share data and resources between the two LANs, what type of device(s) are needed to connect them? Choose the most correct answer.

Q. Your company has a LAN in its downtown office and has now set up a LAN in the manufacturing plant in the suburbs. To enable everyone to share data and resources between the two LANs, what type of device(s) are needed to connect them? Choose the most correct answer.

A. Modem B. Cable C. Hub D. Router E. None of the above

Similar Questions

1. Protocols are

A. Agreements on how communication components and DTE B. Logical communication channels used for transferri C. Physical communication channels used for transferr D. None of the above

2. The method of communication in which transmission takes place in both directions, but only one direction at a time is called

A. Simplex B. Four wire circuit C. Full Duplex D. Half Duplex

3. Error detection at the data link level is achieved by

A. Bit Stuffing B. Cyclic Redundancy Code C. Hamming Code D. Equalization

4. Which of the following is a wrong example of network layer?

A. Internet Protocol (IP) - ARPANET B. X.25 Packet Level Protocol (PLP)-ISO C. Source routing and domain naming-USENet D. X.25 level 2-ISO

5. The topology with highest reliability is:

A. Bus topology B. Star topology C. Ring topology D. Mesh topology

6. "BAUD" rate means

A. The number of bits transmitted per unit time. B. The number of bytes transmitted per unit time. C. The rate at which the signal changes. D. None of the above

7. Start and stop bits are used in serial communication for

A. Error detection B. Error correction C. Synchronization D. Slowing down the communication

8. Unmodulated signal coming from a transmitter is know as

A. Carrier signal B. Baseband signal C. Primary signal D. None of these

9. How many Character per sec(7bits + 1parity) can be transmitted over a 2400 bps line if the transfer is synchronous (1 "Start" and 1 "stop" bit)?

A. 300 B. 240 C. 250 D. 275

10. Which one of the following network uses dynamic or adaptive routing?

A. TYMNET B. ARPANET C. SNA(IBM's System Network Architechture) D. None of these

COMPUTER FUNDAMENTALS TOPICS